The rad1o was not starting the M0 when powered up by inserting a USB
cable. Interestingly the M0 does start when toggling the power switch.
Resetting the M0 before starting it in `main()` solves this issue.
Starting with this release we will no longer use "unknown" as the
default software version string used in cases where the version cannot
be determined from context. Instead we commit the release version string
to git so that any software built from the tagged commit will have the
appropriate release version string. After the release we will commit a
post-release version string as the new default.
We will continue to use the commit hash as version string when the
software is built inside a git repository.
On macOS 12.6 running libusb 1.0.26, the host was seen to sometimes
make an incomplete ClearFeature(ENDPOINT_HALT) request when
ClearPipeStallBothEnds was called from libusb_cancel_transfer.
The host would send the SETUP packet, and the firmware would
call usb_transfer_schedule_ack to acknowledge the upcoming IN
token. However, the host would then not send the IN token,
proceeding directly to the next SETUP.
Since an empty transfer was queued to schedule the ACK, the
firmware would leak one transfer from the free_transfers list.
After a few iterations of this, the firmware would run out of
free transfers and the next request would hang waiting for one.
Fix this by flushing the transfer queues for the control endpoint
when a new SETUP is received, since that token implicitly cancels
any previously ongoing request.
Previously these calls were leaving the amplifiers on, since the
control settings passed were missing SWITCHCTRL_NO_TX_AMP_PWR and
SWITCHCTRL_NO_RX_AMP_PWR. Use the predefined SWITCHCTRL_SAFE here.
Also move these calls before setting the GPIO pins to output mode,
to avoid driving them to the wrong states briefly first.
Firmware now detects the hardware it is running on at startup and
refuses to run if it is compiled for the wrong platform. The board ID
returned by firmware to the host is now derived from run-time detection
rather than a compile-time value. A separate method to retrieve
compile-time supported platform is added.
On HackRF One, pin straps are checked to determine hardware revision.
This is informational to aid troubleshooting and does not affect any
function.
