Previously this register was reloaded with the same value during each loop.
Initialising it once, outside the loop, saves two cycles.
Note the separation of the loop start ("loop") from the entry point ("main").
Code between these labels will be run once, at startup.
These variables are already placed together; this commit just groups
them into a struct and declares this in a new header.
This commit should not result in any change to the firmware binary.
Only the names of symbols are changed.
This removes the definition of the offset variable,
volatile uint32_t usb_bulk_buffer_offset = 0;
which is actually superfluous. This variable, along with its neighbour
usb_bulk_buffer_tx, is placed explicitly by the linker script. Its type
is defined by the declaration in usb_bulk_buffer.h.
There is no need to define it here, and doing so gives the misleading
impression that its initial value can be changed by modifying this line!
The initialization to zero never actually takes effect, because the
variable is not placed in the .data or .bss sections which are
initialised by the startup code.
The offset and tx variables are both set in set_transceiver_mode
before SGPIO streaming is started, so the M0 code does not use
them uninitialised.
This changes m0_rom_to_ram to read directly from the ROM region, rather
than copying from where .text has been copied to RAM.
Previously the second .text section would be merged with the first one,
so the M0 image would be copied to RAM during `pre_main`. However, on
newer linkers the sections are not merged together so the second .text
section did not get copied to RAM.
fixes#936
Previously, a USB vendor request could interrupt in the middle of
set_freq and make conflicting changes, leaving the HackRF in an
undefined state.
fixes#772
Previously the firmware would re-initialise the bulk endpoints on
every transceiver mode change including a USB data toggle reset,
which could cause the first bulk packet (512-bytes) to be dropped
by the host if the PID no longer matched.
It's not an Si5351C driver thing, but a HackRF thing. Also added a driver function to check if CLKIN signal is valid, and made use of it, instead of opaque register read code.
Perform PortaPack initialization separately from and earlier than UI initialization. Track if PortaPack was detected, provide (mostly useless) pointer if so. Put "weak" declarations into respective headers. Moving #includes around.
